Seite 1 von 1

cable splicing a model gondola lift

Verfasst: 19.01.2009 - 05:00
von vonroll101
does anyone know how to splice minature cable?i need some help.thanks.
robert :)

Re: cable splicing a model gondola lift

Verfasst: 20.01.2009 - 15:30
von C. Gentil
Das würde mich auch interessieren. Hat da schon jemand Erfahrungen gesammelt? (Seildurchmesser 2-3 mm)

Re: cable splicing a model gondola lift

Verfasst: 20.01.2009 - 18:47
von jefflifts
(Ich schreib's mal in Deutsch)
Ich habe letztes Jahr, als ich das Seil vom Mauerlift neu Spleißen musste, eine Anleitung geschrieben. Bei Interesse könnte ich sie hochladen. (Hat ca. 300MB)

Re: cable splicing a model gondola lift

Verfasst: 21.01.2009 - 13:26
von Fabi111
jefflifts hat geschrieben:Bei Interesse könnte ich sie hochladen.
Interesse besteht! :D

Re: cable splicing a model gondola lift

Verfasst: 25.01.2009 - 03:06
von vonroll101
completed the splice!it was very difficult.the cable diameter i did was .093 in size.the 4 splices or tucks stretch out 9 feet.each splice is 2 feet long.as i write this,breaking in the cable allowing it to stretch.i would take some photos,but since the cable is so small,you cant make it out.
robert san diego